To hang a pear at home? you will need a special tool and fasteners. But do not forget about the neighbors.
It is necessary
Pear, fasteners, hammer, drill or hammer drill, pencil, bolts or anchors
Instructions
Step 1
First of all, you need a certain tool and, in fact, fasteners. Regardless of the method of fastening (and there are several of them), you need a hammer, drill or hammer drill, pencil, bolts or anchors. The most common way to hang a pear is by screwing a heavy-duty steel hook into the floor. However, it has significant disadvantages. In addition to the fact that, most likely, with the active use of the projectile, it will simply vomit over time, the level of vibration of the ceiling also increases. Therefore, it is better to use other methods.
Step 2
For example, if this is the last floor and there is only an attic on top, this method would be the best solution. At a distance of 5 cm from one another, two through holes must be drilled. Then take the bolts that are capable of going through the floor slab, with washers with a diameter of at least 50 mm, and fix the pear hook on them. Naturally, bolted washers are screwed on both sides of the floor. heavy loads and vibration.
Step 3
An equally reliable and quiet way to hang a pear is as follows. Two expansion anchors with a thickness of about 1.5 cm are taken. Two holes are drilled in the ceiling at a distance of half a meter from each other (the important point is not to get into the voids) into which these anchors are driven. A strong chain or cable is suspended on these anchors, and a pear is already attached to them. At the same time, for maximum exclusion of vibration, the pear should be suspended not in the center of the cable, but with an offset of 10 cm to one side or the other. Thanks to this technique, any blows on the pear will not cause strong vibration of the ceiling and walls.
