Bindings are not always included in the set of skis. Sometimes the installation of a part falls on the shoulders of the buyer. Fortunately, this work can be done by yourself, having studied some of the features of the mounts.
It is necessary
- - drill;
- - fasteners;
- - templates;
- - drill 3, 6 mm;
- - awl;
- - crosshead screwdriver;
- - PVA glue;
- - screws.
Instructions
Step 1
The bindings type nn 75 are a modern option that is suitable exclusively for plastic professional and semi-professional skis. It is categorically not suitable for wooden and semi-plastic options. Bindings nn with a length of 75 mm do not distinguish between right or left ski, since they are suitable for absolutely each of them. Buy exactly the skis and bindings that fit together.
Step 2
First of all, make holes on the upper surface of the skis according to the template. Calculate the center of gravity of each ski by placing a flat ruler on top of them. Next, very carefully create the holes according to the previously attached drawing. A similar template should always be included with the mounts.
Step 3
Mark with an awl for future holes. This is necessary so that the drill does not go to the side and does not spoil the skis. Carefully drill the first 3 holes for the main screws. They should be parallel, as this will affect the position of the boots when riding. Try not to make mistakes at this stage. Keep the drill straight and everything will go smoothly. Also make 3 more holes in the back to reinforce the plastic boot liner later. It can also be adjusted when screwing.
Step 4
Fill all the drilled holes in the skis with glue, as the screws simply cannot hold any other way inside. In addition, PVA glue will prevent snow from penetrating into the hole. Next, tighten the 2 supporting screws under the brackets. Snap on the plastic backing.
Step 5
Tighten the screws to install the plastic backing. Then snap the fixing cover and stick the protective strips (stickers) on the screws. That's it - the job is done! If you follow these instructions, the installation of the mounts will not take you more than 30 minutes. Everything must be done carefully so that there are no troubles on the track.
